Arlumen has developed a high-power laser lighting system designed for deterrence applications to protect sensitive sites and armies. The system was designed for GEIM, a company based in Lorient, with the support of Laser Conseil. The laser has a dazzling effect which slows down or neutralizes people located in the beam, and meets laser safety requirements: this product is equipped with safety systems enabling it to be used without risk (Class 2M product).
It can only be switched on if the emission field is completely free for the first 100 meters. If a person or object is present, the laser cannot be switched on, or switches off if a person enters the danger zone. Switch-off time is less than 0.1ms. With 5W optical power output, it dazzles the surface of a windshield at 500m.
Arlumen designed the optical system for shaping the laser, as well as the drivers and optimization of a safety system based on Lidar technology.
Intercepting intrusions in civilian and military environments
Faced with the need to protect sensitive and strategic sites against intrusion, the customer wanted to develop a system capable of deterring intruders from a distance. Arlumen acted as an expert partner in optics and electronics to design, optimize and produce a high-power laser dazzle device, guaranteeing high performance and maximum safety under real-life operating conditions.
Purpose of the laser deterrent
Design and produce a non-lethal laser glare system to intercept intrusion attempts from a distance.
Technological challenges of the optical glare control system
The glare control system needed to reconcile high laser power, maximum safety and advanced opto-electronic integration. It must :
- Guarantee an output power of 5 W to ensure glare-free operation at a distance of over 100 m.
- Transforming an intrinsically hazardous laser (class 4) into a safe class 1 device to prevent harm to people in the vicinity of the system.
- Automatic beam cut-off if an obstacle is detected less than 100 m away.
- Ensure multiplexing and coaxial alignment of the power lasers with the lidar Time-of-Flight (TOF) detection laser.
- Integrate thermal control of lasers to guarantee stability and reliability.



Optical solution designed by Arlumen
Arlumen has developed and produced a small series of 12 laser deterrent and interception systems, incorporating :
- A complex optical system capable of multiplexing and coaxially aligning two high-power green lasers (525 nm - 3.5 W and 550 nm - 2.1 W) with the 905 nm TOF laser.
- Beam shaping to create a circular/elliptical glare zone adapted to different protection scenarios.
- An electronic board dedicated to immediate beam cut-off, based on a TOF lidar adapted for very fast response times, guaranteeing laser safety over a distance of 100 m.
- Peltier module control electronics dedicated to laser frequency doubling, guaranteeing optimum conversion and maximum efficiency.
- A camera and supervision interface to image the laser spot, check beam alignment and monitorperformance.
Laser deterrent performance
- Laser with 5 W output power and Class 1 safety level
- Active protection system for the first 100 meters
- Automatic laser cut-off time <0 .1 ms
- Temperature control to ensure laser efficiency
